|
故障 Troubles |
產生原因 Causes |
排除方法 Remedies |
|
No Water is discharged 水 泵 不 出 水 |
1．進水管或油封處漏氣Air leakage exists in
inlet pipe or in sealing
parts． 2．泵體內儲水不夠Water stored in the pump
boay is insufficient． 3．水泵反轉Revolution direction reversed． 4．進水管太長Length of inlet pipe is too
long． 5．吸程過高Suction lift is too high． 6．出口閥關閉無法排氣 Outlet valve is turned
off unable to discharge
air． |
1．檢修進水管，適當壓緊填料或更 換 Repair the inlet pipe，press sufficiently the
sealing filler or replace it． 2．增加儲水，檢查泵內逆止閥是否 密封或堵塞Increase the storage of water．Examine
whether the check valve in the pump
is sealed or blocked． 3．檢修糾正Check and correct it． 4．縮短進水管shortenthe inletpipe． 5．降低吸程Lowerthe suctionlift． 6．打開出口閥或泵體上的螺塞Turn on the outlet valve，or
the．screw plug on the pump body．． |
|
Quantity Of flow is not enough 出 水 量 不 足 |
1．濾網或葉輪堵塞Filter gauze valve or vane
wheel is blockcd． 2．密封環處漏水嚴重 Serious water
leakage in the sealingring． 3．揚程太高The lift is too high 4．進水管漏氣Air leakage exists in the inlet
pipe． 5．吸程過高，局部產生汽 蝕Suction
lift is too high． Local vapour
etching appears． |
1．清除堵塞物Clear the blockage． 2．更換密封環Replace the sealing ring． 3．降低揚程Lower the lift． 4．檢修進水管Repair the inlet pipe． 5．降低泵安裝高度，減少進口阻力 Lower the
installation site of the pump to decrease
the inlet resistance． |